Techinical Details
Special Tools for Special Jobs
Bunishes two different bore diameters separately or simultaneously. Practical for thru- hole and blind- end application. Recommended for high- column use only.
Single Point ToolCan be mounted on a lathe to burnish an entire rod Does a fine job on motor shafts, pump shafts,any Propeller-type shafts. Suitable for most CNC turning centers.
Outside Surface Roller Burnishing Tools- Reduce cost by eliminating finishing operation on secondary work centers.
- Suitable for most CNC turning centers.
- Produce high quality finishes (0.13-0.20um)
- This tool design employs a long life 45mm diameter carbide roller with a heavy- duty bearing rotating on a hardened axle. The carbide roller is a spring loaded in two axial directions to provide the correct pressure for the burnishing operation. The carbide roller can be reground several times as required.
Available in angles from 0 to 90° with minimum center hole diameter of 9.5mm.Force feed or hand feed. In an automated Setup, a compression spring adapter or Controlled pressure system should be used to maintain uniform pressure and Dwell- time.
Surface ToolsFinishes flat surface where minimum Center diameter is 1.57mm. compression spring adaptor or controlled pressure system should be used to maintain uniform pressure and dwell–time.